Plastic particle crusher repair and maintenance

1. In the process of daily use, the plastic granule crusher should check the rotation of the disc from time to time. According to the specific provisions of the plastic granule crusher, the rotation speed of the disc should be controlled within a reasonable range to avoid the disc rotating too fast. And affect the product's granularity.

2. As the plastic granulator is a wet granulator, the upper part of the disc is usually equipped with a spray device to moisten the material and increase the viscosity of the material. Therefore, in order to ensure that the material has good blocking, it should be checked frequently. Spraying device to ensure the smooth flow of water in the spray device.

3. In the process of using the plastic granule crusher, it is necessary to pay particular attention to the inspection of the transmission parts of the plastic granule machine, that is, the drive gear, the rotation of the drive gear is completed with the assistance of the lubricating oil, so the operation of the gear In the process, it is necessary to regularly check the lubrication conditions, add appropriate lubricants and greases to the gears, ensure the good lubrication of the gears, and make the operation of the plastic pellet machine more stable and reliable.

4. The overall structure of the plastic granule crusher is supported by a frame. When the machine is running, pay attention to check the anchor bolts connecting the pedestal and the ground. Check if there is any looseness. If loose bolts are found, be sure to Timely tightening, otherwise the plastic particles machine will produce strong vibration and noise, even cause accidents.

5. Check whether the parts of the machine are lost during the transportation of the plastic granule crusher and whether the bolts are loose.

6. The plastic granule crusher rotates the spindle pulley and checks whether there is a collision when turning.

7. Check whether the rotation direction is correct after wiring the motor of the plastic granulator.

8. The crushed material in the plastic granule crusher is strictly prohibited from being mixed with iron and impurities.

9. The plastic granule crusher found abnormal noise and should stop immediately.

10. Regularly check the lubrication of the plastic pellet mill bearings and inject the lubricant.