The production cabinets of different kitchen cabinets with different production equipment have large differences. Therefore, it is necessary to adjust the product structure according to the specific equipment conditions of the enterprise, so as to maximize the utilization of existing equipment to achieve high efficiency and low consumption. The design of the extruded kitchen cabinet should be considered. Although the overall kitchen cabinet is similar to the panel furniture in terms of product structure, its structure is more complicated than the general panel furniture due to its functions and equipment. When designing the kitchen cabinet structure, The following points should be considered: function is relative to other panel furniture, functionally speaking, the overall kitchen cabinet should meet the operational requirements of storage, washing and cooking.
Eccentric joints are commonly used joints for panel furniture. They are commonly used for right angle joints of wood panels. They are characterized by beautiful appearance, stable structure, repeated disassembly and assembly, and combined strength to meet requirements. The structural design of the eccentric joints needs to be accurately calculated. The eccentric parts produced by different manufacturers are calculated differently, and can be referred to the factory instructions.
The eccentric joint and the wood-studded joint wood screw joint are connected by the special screws of the particle board (or the MDF). This method is not suitable for the production of ordinary panel furniture due to the appearance of the nail head and the low production efficiency. More common, but in the kitchen cabinet manufacturing has its unique application advantages, one is that its joint strength is better than the eccentric parts; second, the inside of the cabinet does not see the installation hole, the cabinet has good sealing, can prevent moisture from eroding the cabinet And the discharge of free formaldehyde; the third is that its processing accuracy is not high, and no special equipment is needed; the fourth is that the kitchen cabinets are mostly embedded installation (three sides against the wall), the nail head is completely covered by the wall, and does not affect the appearance.
Therefore, the cabinet is made of wood screws. It is suitable for small cabinet companies with small batches of products or small decoration companies that make kitchen cabinets on site.
The height of the reverse retaining water is generally about 10, so that the water on the countertop will not flow to the kitchen floor, but it is required to set a countertop that is opposite to the water retaining. The wash basin must be installed in an embedded or understage manner to make the wash basin low. On the countertop plane, in order to eliminate the moisture on the countertop.
Shampoo And Conditioner,Magic Hair Dye Shampoo,Biotin Collagen Hair Conditioner,Keratin Leave In Conditioner Spray
SOLO GLOW HAIR COSMETICS , https://www.hairstylingwaxfactory.com