How to install a slim light box, which need to pay attention to

Slim light box should pay attention to the problem during installation:
1. After removing the protective film from the light guide plate, contact with the light guide plate with wet hands or sweat should be avoided;
2. During the transport of the ultra-thin light box with light guide plate, it should avoid arbitrarily rubbing and bumping against the surface of the light guide plate; the leakage of sand into the light guide plate should be avoided when the light guide plate is placed at the original place; when the light guide plate is cut, it should be cleaned and cut. Foreign material on the surface of the bed;
3. Avoid directly cleaning the surface of the light guide plate with non-cotton materials.
And to achieve a clean effect. Third, the surface of the light guide plate scratches common sense:
1. Lighter scratches can be wiped with alcohol to reduce scratches;
2. Deeper scratches can be polished with electric roller [cloth roller], which is a common method for acrylic products.
For example, the dirt and scratches on the surface of the light guide plate are more difficult to handle, or the processing work will affect the overall work efficiency; the following methods can make up for the defects caused by the surface of the light guide plate on the product:
1. If there is a certain spatial distance between the display screen of the light box or display and the light guide plate, the defects on the light guide plate will not be seen after the screen is installed;
2. Special light-colored images or pictures clinging to the light guide plate must be covered with a diffusive film on the defective light guide plate. Generally, they can completely compensate for the surface problems of the light guide plate. The dirt on the surface of the light guide plate is mainly dust, fingerprints and pouring. Residual water stains. Handling common sense is as follows:
1. Use a cotton fabric and alcohol to wipe off all the above dirt;
2. After wiping with alcohol, it should be air-dried or blow-dried; otherwise, the surface of the light guide plate will have residual moisture, which will produce bright spots after contact with the reflective material or the screen;
3, if the surface of the light guide plate is not very obvious dirt, it is recommended not to wipe, or improper handling will produce new scratches;
4, light guide plate, such as static electricity is easy to pay dust, and is not easy to clean; use 1% of soapy water, with a soft cotton cloth soaked in water can easily remove dust.