Almost every household has installed natural gas. When we use it, we must always observe our use in time to avoid the insufficiency of the remaining amount of gas. The following small series teaches everyone how to look at the natural gas meter .
the first:
1. In the process of user gas consumption, the microcomputer in the IC card smart meter automatically reduces the remaining air volume. After the purchased air volume is exhausted, the valve will automatically close the valve and the gas will be shut off. The user needs to re-purchase the gas to open the valve of the IC card gas meter again. Gas supply.
2, IC card can also record the operation of the gas meter, under the management machine or management software to manage the total gas consumption, total gas consumption, switch valve status and other information.
3, IC card gas meter can improve management efficiency, effectively prevent arrears, and avoid home meter reading. It is suitable for the measurement of flow such as natural gas and gas.
4, prepare the IC card and flashlight, usually the gas meter is installed under the stove, relatively dark.
5. Move the battery cover to the upper right side of the battery cover and open the battery cover.
6. Insert the gas card face up into the gas meter and you will hear a tone.
7. The above shows how many cubic meters of gas are used. The balance shown below.
8. Remember to insert the purchased IC card (one end of the chip, the chip facing down) into the card slot, and the LCD screen displays the amount of available gas (if there is a margin in the table, the accumulated number is displayed).
9. Wait for 5-10 seconds (or the LCD goes out). The air volume in the IC card has been entered into the meter (only one valid input). Please take out the IC card and keep it in a safe place.
10. When the remaining amount of the gas meter is lower than the minimum alarm amount, the buzzer will continuously sing. When the gas is used until the remaining amount is zero, the valve will automatically close. At this time, the gas meter must be recharged to open the valve.
second:
There may be different tables depending on each family. You can look at the table like this:
1. The pointer gas meter is similar to the water meter. The one digit pointer turns 10 times in a clockwise direction, and the ten digit pointer advances one counterclockwise. The ten-digit pointer turns 10 times counterclockwise, and the hundred-digit pointer enters one.
2, the calculation of gas consumption in general, the gas meter readers copy the table every month or February, and basically fixed on the same day.
3, the household membrane gas meter has an 8-bit character wheel, of which the front 5 black character wheel, the back 3 red word wheel.
4. The black character wheel represents an integer, the red character wheel represents a decimal, and at the same time, on the outermost nameplate, there is a decimal point, so that you can see at a glance.
5, word wheel, LCD double display gas meter, such a table is mostly a fabricated IC card table, is a combination of word wheel counting and liquid crystal display.
6. The meter reading method is also a combination of the word wheel reading method and the single liquid crystal display reading method.
7. The current residual air volume can be read from the LCD screen daily, and the accumulated air volume can be conveniently read from the word wheel counter.
Now we have read the above explanations, how to teach everyone to read, see, and the natural gas meter correctly. I believe that in the future, you will not be unclear whether your home is left or not, how much energy can be used normally, and worry every day. This is our decoration home network to tell everyone, I hope you will pay more attention in the future, thank you very much!
Children Bed,Children Hospital Bed,Children Healthcare Bed,Children Medical Bed
Jiangmen Jia Mei Medical Products Co.,Ltd. , https://www.jmmedicalequipment.com