There is always one applicable to the eight major drift methods

One, double bait fishing float

Floating fishing: The total weight of the fishing group after double hook bait fishing, no buoys with large buoyancy, so after hanging bait, double hook bait can be easily placed in the ideal water layer. Generally suitable for semi-water fishing non-benthic fish, such as Japanese white peony, brook fish, grasshoppers and so on. Pond fishing fish is also used nowadays: for example, pull, a standard deep. This method is theoretically the most sensitive as long as the hook is not in the end. The fish will be a little closer and the buoy will respond.

Second, double bait tune a few orders

Double-hook bait hanging bottom, adjust the lead skin to the end of the water a certain number of nets (usually no more than 3 mesh), this method is actually in the floating fishing blunt range, bottom fishing is the most sensitive area. If you use the double hook hook bait tune 3 heads as an example, how to find the end? Available anti-adjustment method: the first buoy buoy to catch 4 heads (greater than heading) to ensure that the bait has bottomed; then in the complex buoy In a little bit, the target will be adjusted to 3 heads. At this time, the bait will touch the bottom, the bait will hang at the bottom, the bait will move, and the catch will be caught in the bait. This is the most sensitive kind of buoy tune. As long as it is not suitable for fishing, it is especially suitable for fishing rods.

Third, double bait leveling water

Double bait leveling water, empty hook leveling water, and hook-free leveling water can be set as the zero buoyancy modulation of the so-called residual buoyancy=0. Double bait leveling water belongs to catch “shallow swallow”, which reflects the zero buoyancy of instant fish information; empty hook leveling water belongs to zero buoyancy of “deep swallow” and “head up” fish information; no hook leveling water belongs to catch After the bait turned, "delayed buoyancy was delayed. The double bait flat water adjustment method is the same as that of the double bait tune, except that the tune is set to be flat water. As for how to find the bottom? In principle, as long as you see the fishing target, the hook bait will be determined to the end. If the fishing target is set to 2 heads, then the lower hook wire has about 2 lengths of bent or undercover. According to this analogy. After the double bait has leveled the water, the bait can't hang at the bottom and the bait can't touch the bottom. This is a very high-sensitivity tune. Except for light mouth and squid, other basic fish can be used.

Four, single bait leveling water

Hold the hook on the hook or under the hook and place it on the bottom. After this single bait fishing group is balanced, as long as the bait is hung again, the entire fishing group will sink until the bottom bait touches the bottom and the bait lightly wipes the bottom (the supporting force of the bait strand does not count); therefore, no The bottom problem. This method of adjustment, the user is more than double bait flat water, more suitable for fish species. ... In the single bait weight conversion (thin tail) everyone used to listen to - "Tune 4 fishing 2" is located near the point! The reason why "4 fishing 2" will be selected as the entry method, it should be related to the law of large numbers. The advantage of adopting this upward adjustment method is that the addition of the variable “bait weight” is actually more accurate than the downward adjustment method of “impossible bait hooking 2”, which causes the bottom bait to bottom out. The bait bottomed out and counted as a slightly blunt fishing method, which was suitable for use under normal conditions.

Fifth, empty hook leveling water

This method of adjustment has already belonged to the method of lowering bait. After adjusting the water with an empty hook, raise the buoy seat without pulling the bait and pull it to the water surface. The bottom hook is on the bottom and the top hook is on the bottom. Such as hanging on the double bait (regardless of size), is always on the bottom of the bait, the bottom bait lying (relative to the extent of the double hook distance). If you add a fishing target, for example, catch 2 eyes, the upper bait line starts bending because of the length of 2 more points. This adjustment point is the starting point of the double bait trailing fishing, and it is also the middle point of inaction. After this point, it turns into a dull world. When the waves are large and the water flow is disturbed, this method has the effect of stabilizing the fishing group. Because the double hooked bait state is relatively stable, it is more suitable for the winter skis and Luo Fei.

Six, no hook water level

Remove the double hooks of the strands, leaving the fishing group above the lead seats, and adjust the buoys to flat water from the bottom. After the completion of the adjustment, hung double hooks, double baits, and raised the buoy seat so that no more than 2 heads are exposed. This means that there is no hook and level water adjustment. At this point, double hooks are undercover and the strands are bent. Need to add dual strand support. After testing, with the water depth, the same point of fishing, regardless of the length of the sub-line, the buoys in the suspended state will be the same as the ones exposed on the water surface. If the strand is too long and the bending range is large, it will inevitably prolong the response time of the fish signal. If it is not a super fish, it should not be necessary.

Seven, lead light touch bottom

At the end of the day, if the lead is adjusted more than a little bit of “no hooked water”, the lead skin seat must be bottomed out. At this time, it has begun to enter the bottom of the sinking range, so it is not necessary or able to carry out the adjustment. If it is necessary to use it, it is recommended to use live lead or lead, which will be helpful for delicate fish and special circumstances. Otherwise, you can only catch the fish when the summer bite. Individuals should first weigh the number of double-bait weights before eating an appraisal, and be aware of them. Then select a suitable one from the above range based on factors such as fish, weather, water conditions, and fish conditions. The scope of the seat to adjust the bid;

Eight, run lead

Add lead to far more than the float to eat the amount of lead, so that the fall of the lead lying down, push up the space above the lead bean, so that the main line can be active within the lead seat, use lead when running as short as possible, to avoid Too much wasted information. This type of fishing method is suitable for use in the case of water and in the case of a large amount of miscellaneous fish. It can be used quickly and not affected by currents.