Recently, many people have reported to this reporter that there are always some small insects near the furniture, especially the furniture of the damp old houses are more likely to be smothered by small insects. To this end, experts advise that summer heat and moisture can easily breed bacteria and insects, some of which can damage wooden furniture and flooring.
Among all kinds of wood, natural eucalyptus, teak, fir and boxwood have the function of preventing insects, while other woods, such as cherry, eucalyptus, eucalyptus, mahogany, etc., do not have the function of preventing insects, and need to be made in furniture. Take measures to prevent insects. Between different natural woods that are not pest-proof, the difficulty of insects varies. For example, eucalyptus is less pest-proof than sakura, but all wood produced into furniture has been treated.
In general, some furniture will be treated with insects during the production process. For example, in the processing, the physical method is adopted to carry out the insecticidal technology of constant temperature and constant pressure on the wood; the wood material is soaked with the insecticide medicine; the wood material is covered with the plaster or the fireproof paint. In addition, painting solid wood furniture is also an anti-insect measure because the paint prevents the furniture from absorbing moisture and keeping it dry. The same is true for solid wood flooring, and when laying solid wood flooring, workers put anti-insecticides under the floor or sprinkle wood powder.
Compared with solid wood furniture, sheet furniture is a lot of worry. Because the sheet furniture is produced by high temperature and high pressure, and it is fully edged and trimmed. In the trimming, a standard trimming paint is used to prevent the board from being exposed to the air, which effectively prevents the furniture from getting wet. The general brand will reduce the occurrence of mold and insects through strict production processes when producing plates. Today, particleboard, MDF, etc., which are commonly used in the market, are basically free of insects. In addition, the inside of the board contains adhesives and fillers, which prevent the occurrence of insects to some extent.
Whether it is solid wood or board furniture and flooring, insects can only occur in the case of moisture; and wood is very easy to absorb moisture, so to prevent the occurrence of insects, the insect control measures taken in the early production process are not enough. The consumer also needs to be carefully cared for during use.
â– Insecticide measures
Large pieces of furniture are repeatedly wiped with disinfectant
Once you find furniture or floor worms, you need to find an epidemic prevention station or a community tube to carry out insecticides. Small pieces of furniture that have been wormed can be sun-dried and then sprayed with insecticide. Large pieces of furniture can be wiped repeatedly with disinfectant several times, dried thoroughly, thoroughly ventilated and dried, and then sprayed with insecticide. It should be noted that if you want to improve the use of pesticides, it is best to put the insecticide-coated furniture in a confined space to facilitate the penetration of pesticides into the furniture and reduce volatilization.
â– Preventive measures
Reduce ventilation when outdoor air humidity is high
In areas with humid air, dehumidifiers should be used frequently in the home to reduce the impact of excessive indoor humidity on the furniture. When the humidity of the air is high, the doors and windows can be closed to reduce ventilation. Desiccants and insect repellents can be purchased in supermarkets or furniture malls, placed in wooden furniture and in the home's easily damp corners. It is also possible to place the wooden furniture in the sun on a regular basis, but be careful not to place it in direct sunlight, which may cause the paint on the surface of the furniture to fade or even fall off. In addition, the placement of wooden furniture is also very particular. It should be kept away from air conditioners and heaters, which will not easily cause moisture and damage to wooden furniture.
Damaged wooden furniture surface or accelerated insects
In the air-conditioned room, a few pots of flowers or fish tanks should be placed to maintain a balanced indoor humidity. Put a layer of soft film on the furniture, and gently handle it in the vertical direction to avoid damaging the furniture surface. If there are scratches on the surface, you should promptly find a professional to repair the insects.
The feet of the furniture should be placed with rubber pads to avoid damage when moving back and forth; do not drag, pull or smash when moving, to avoid damage caused by uneven force on the furniture.
The rags that wipe the furniture should be clean and soft, and there should be no Water drops or watermarks on the furniture after wiping. Any damage to the surface of wooden furniture can accelerate the moisture and insect speed of the furniture.
If the edge of the panel furniture is trimmed and trimmed, the moisture will not be released after being inhaled from the position of the trimming gap. After a long time, the inside of the board will be worms. Therefore, it should be dried immediately, for example: Dry, sun, etc., then lightly sand, for a second trim, to enhance the sealing effect. These measures can also be used to protect wooden floors.
â– Master tricks
Netizen alix: If the furniture is wormed, you can use the sharp pepper or pepper to smash into the end, stuff it into the insect hole, and then apply the paraffin oil in the place where the insect is licked, and it will be smeared for 10 days. Only tableware and other furniture such as cabinets cannot use insecticides and paraffin oil.
The ideal of netizen vegetables: When some communities trim the eucalyptus, the discarded branches are about 40 centimeters. The branches can be picked up, sawed into 2-3 cm thick, and then placed in different parts of the house one by one to prevent insects. I have used it for many years and it works well.
Mr. Ge: I will regularly wax some furniture. For the newly bought wooden furniture, if there is an unpainted part inside, I will brush it with varnish to prevent insects.
Ms. Li: I live on the first floor of the community and it is a shady face. The home is darker and the environment is damp. In order to prevent the solid wood furniture from being wormed, I laid a thin floor mat or carpet under the furniture to reduce the moisture absorption of the furniture. Once the furniture is insects, you can buy a small amount of pesticides, find the location of the insects, use the needle to get the medicine into it, and then seal it with wax.
Coffee Jug use ways is blow:
1)Place the pot on a dry, flat surface. Hold the handle firmly, then pull out the plunger
2)Add a heaping tablespoon (7-8 grams) of Coffee to the pot per 200 ml (6.7 oz) of water
3)Pour hot water-not quite boiling-into the pot, and gently stir
4)Carefully reinsert the plunger into the pot, stopping just above the water and ground coffee (do not plunge yet), and let stand for 3-4 minutes
5)Press the plunger down slowly, exerting steady pressure.
6)After each use, wash the pot with water and mild detergent, and dry thoroughly
Coffee Jug
Coffee Jug,Glass Coffee Filter Jug,Lid Glass Coffee Jug,Glass Coffee Jug Bulk
Hejian Jia Teng Glass Products Co., Ltd. , http://www.jtglassware.com