[Company Sports Equipment Co., Ltd. official website news] You are really good, back to the company's official website, thank you for the high value of the face, but also to read Xiaobian articles, hoping to get your resonance and inspiration! The company's brand amusement equipment and children's slides: suitable for playgrounds, parks, kindergartens, communities, shopping malls and other indoor and outdoor places, set fitness and entertainment in one, to bring children a different experience!
First, the ground installation of the equipment and the structure buried underground shall meet the following requirements (except for equipment with a larger ground frame type base):
1. The pillars buried in the underground equipment shall be firmly fixed to the lateral support or support plate;
2. The soil quality of the installation equipment should be within the depth of 800 mm from the surface of the ground. It should be the type II non-porous and non-sand loam soils with a fastening coefficient of not less than 0.7. After effective treatment, equipment can be installed;
Note: Type II hard earth with a tightening coefficient of not less than 0.7 can be determined by the difficulty of excavation with iron shovels and the difficulty of excavating with a few rakes. Soils that need to be excavated with shovels and excavated with a small amount of excavation can be regarded as Type II hard soils with a tightening coefficient of not less than 0.7.
3. The depth of equipment pillar buried in the ground: when the height above the equipment surface is ≥ 2000 mm, it should be no less than 500 mm; when the height above the equipment surface is ≥ 1000 mm and <2000 mm, it should be no less than 400 mm; When the height is less than 1000 mm, it shall not be less than 300 mm; below the bottom of the equipment column, there shall be a concrete supporting layer not less than 100 mm thick;
4. The horizontal dimensions of concrete foundation pits for supporting columns of installation equipment shall not be less than 400 mm*400 mm, and the concrete foundation shall not be disposed as large and small;
5. The strength of the concrete used in the pouring equipment foundation shall not be lower than C20, and special supervision shall be provided before the foundation is completely solidified;
6. After the equipment is installed, the supporting pillars and the main body shall be perpendicular to the installation ground. The verticality tolerance shall not be greater than 1/100;
7. The ground surface 0.5m away from the outer edge of the equipment foundation should be hardened, for example, the concrete hardens and the masonry after compacting the soil; the hardened surface of the foundation and surrounding equipment should not be higher than the ground around the installation equipment.
Second, the installation site and the surrounding environment should meet the following requirements:
1. The horizontal distance between the equipment and overhead high and low voltage wires should not be less than 3 m;
2. The horizontal distance between the equipment and the edge of underground pipelines and underground lines shall not be less than 2 m, and the horizontal distance from all kinds of office buildings, residential houses and all kinds of buildings shall not be less than 5 m;
3. The place where the equipment needs to be used at night, within 2 m of the edge of the equipment, the illumination should not be less than 15 lx;
4, equipment should be away from flammable, explosive and toxic and hazardous items, site fitness should be consistent with the state's safety regulations.
3. Equipment such as horizontal bars, parallel bars, ladders, swings, etc. that bounce up or down or may fall from the air, and its sports ground should be soft or elastic buffered ground, such as sand and rubber floors. In the case of a rubber floor, the structural thickness of the floor shall not be less than 25 mm; in the case of a sand pit, the thickness of the sand layer shall not be less than 200 mm, and the perimeter of the sand pit shall have an appropriate height of raised platform enclosure, and the ribs of the bosses. Edges and sharp corners should be set with rounded corners with a radius of not less than 10 mm.
Fourth, the distance between the body movement range of the sports station and the sports station should not be less than 1 m.
V. The design and installation of equipment shall ensure stability, reliability and verticality. There shall be no loosening and shaking of the basic components and supporting components.
Fitness equipment manufacturers - the company's pleasure
For more information, please return to the company's official website of Sports Equipment Co., Ltd. Advisory telephone. The company's pleasure and dedication to serve you! Factory address: No. 16, Chuangqiang Road, Lucheng District, Wenzhou City Light Industry Park.
Chinese Cantonese Wok Pan,Nonstick Wok Pan,Stainless Steel Wok Pan,Deep Frying Wok Pan,Honeycomb Frying Wok Pan
Shangwey Cookware Co.,Ltd of Jiangmen City , https://www.shangwey.com